Umarex Colt 1911 A1

The Umarex Colt 1911 A1 is a replica of one of the most iconic handguns ever produced. This was the standard sidearm for US military from 1911 until 1985, when it was replaced by the Beretta 92. Like the Berretta 92, the Colt 1911 firearm operates on short recoil. It is also known as M1911.

This Umarex airgun replica was actually produced before any of the other Umarex guns that I reviewed so far. Like the Beretta, it is made in Germany.

Operation

The Colt 1911 works very much like the Beretta 92FS, except for the safety aspects where Umarex has replicated both safety types of the firearm.

Loading a CO2 cartridge requires pressing the button on the left grip to push the right one out. You then need to pull out what looks like the magazine bottom and to unscrew the screw attached to it. Oil the tip of the CO2 cylinder, insert it and tighten the screw against its bottom - no effort is needed in this tightening, just ensure that the cylinder is not loose. Then replace the grip and slap the "magazine bottom" lever to pierce the cartridge.

Next step is to load pellets in one of the standard 8-pellet clips used by Umarex. To load the clip, open the slide by pulling down on the left side lever located above the trigger. Drop the clip in there, ratchet teeth towards the rear of the gun, and push back the slide.

Up to this point, everything worked like on the Beretta. Now comes the different part. To shoot, you need to deactivate two safeties. The first one - the thumb safety - is a one sided lever on the left side of the gun. When this is on, it disengages the trigger from operating the hammer (like on the Walther PPQ). Push it down to deactivate it. The second safety is the grip safety - you just need to hold the grip to engage this - without it being engaged, the hammer cannot strike the firing pin (well, the gas-release valve on this replica). The gun is now ready to fire.

If the grip safety sounds strange, do not worry: it operates very nicely when you just hold the gun as firmly as you would hold any other gun.

Like the Beretta, this Colt can fire in double action mode (just pull the trigger) or in single action mode (cock the hammer before pulling the trigger).

Package and build

As all other Umarex metal replicas, the M1911 comes in a plastic case with all its materials and accessories. This case is much nicer than those used with all other Umarex guns I tried so far. It lacks the precut foam and the etched firearm company logo (it just has a sticker), but it feels much more rigid and solid than the other cases. It is basically of similar sturdiness to Plano cases, whereas the usual Umarex cases were a notch below. This was a pleasant surprise.

The Colt comes with two clips, a key, a manual, safety instructions, and a promotional poster. The key can be used for adjusting the rear sight, just like on the Beretta.

I had mentioned a bunch of minor issues with the build of the Beretta. Fortunately, none of these were present for the Colt. In particular, the CO2 compartment was uniformly finished and the metal piece of the removable right grip had no traces of rust. The Colt is entirely made of metal except for the grips, which are made of what feels like rubber on my model (you can also choose wood, if you prefer). Even the sights appear to be made of metal. On the Beretta, I was annoyed by the looseness of the front sight, but this is not an issue with the Colt. Getting back to the grips, Umarex mentions that they are plastic, but to me they feel very much like rubber, so either they switched to using rubber or they used a very special plastic that feels like rubber. Regardless, the feel of these grips exceeded my expectations (I expected some plain plastic).

Bottom line is that the build of this Umarex pistol has no faults - it is a very very nice replica.

Let me comment a bit on a few more differences from the Beretta:

- the grip lever for piercing the CO2 extends much more in front of the grip than on the Beretta
- the right grip does not pop out as easily when pressing what on the firearm is the magazine release button. This is because the grip has two long pins for aligning it on the handle and, their material being flexible, they have more friction against the metal holes in which they are lodged; just pull the grip and do not be afraid to bend these pins a bit.
- the slide of the M1911 closes very nicely with a more muted sound than on the Beretta
- the handle of the M1911 is thinner than the Beretta's and it feels just right to me; the Beretta handle always felt "fat"

The Colt 1911 was offered in black and nickel with wood or plastic grips, but I have not seen the nickel version in merchant listings so far, so that may have been discontinued.

Adjustable settings

Like with the Beretta 92FS, the only adjustable setting is the rear sight, which can be adjusted for windage using the provided key. To do so, loosen the sight, then move it manually and re-tighten it - this is a bit finicky, but I only had to do it once.

Performance

In double action mode, the trigger operation feels rough. It will probably get better in time, but so far I can only say that it works, but I prefer the double action of any other airgun I reviewed so far. Single action is very interesting - the effort that is needed here is very small, which helps accuracy, but you do need to pull the finger all the way towards the handle for it to fire, which I am still trying to get used to. That being said, the little effort required in this mode meant that I could get much better accuracy from the Colt than I did from the Beretta after a similar breakdown period.

The sights work well and switching between this and the Beretta I realized that both of these need to be aimed exactly like the manual says - under the bullseye, otherwise you will shoot high.

The M1911 is an accurate airgun. It can probably fire as well as the Smith and Wesson 686 with practice, but the lack of full sights customization will make it more challenging.

CO2 use is very good. Like with the Beretta, you can get 60-80 shots easily (depending on ambient temperature) and you can push it well beyond if you do not care about clean target holes.

Conclusion

The Colt 1911 is a very nice pellet airgun replica. It has an excellent build, it handles nicely, it is accurate, and it has a unique enough mechanism (safeties + trigger) that it can complement the possession of another Umarex pistol replica. If you only want to get one Umarex pistol, this is a good choice. If you are intrigued by the S&W 686 as well, make the choice based on whether you prefer a pistol or a revolver.