Crosman 1377C American Classic

Sometimes, I just want to practice a few shots and be done with it. With the Beretta 92FS I have to go through many targets to exhaust a CO2 powerlet, so I started looking at pneumatic and spring piston airguns. The Crosman 1377C was both held in high regard and available at an affordable price, so I had to give it a try. This airgun is available with brown or black plastic grips and I picked the black version, which is listed as PC77 Pumpmaster Classic on Crosman's site - there is no difference between them other than the color of the grips.

Operation

The "classic" aspect of this airgun's name comes from its design originating with Crosman model 105, which was manufactured between 1947 and 1953. So this design has been around for some time and the fact that it is still sold today is a testament to its quality.

The 1377C consists of a long barrel sitting over the compression cylinder with the pump masking as the forward grip. The manual states that the pistol should be pumped at least 3 times and no more than 10 times. Pumping it less than 3 times could lead to a pellet getting stuck in the barrel (although I did an experiment and even one pump will work, but with little force); pumping it more than 10 times will not increase the shot power and might damage the pistol's seals, so it is best avoided. For target shooting, I started with the minimum 3 pumps, but now I use 4 pumps, to get cleaner holes punched in the paper target. With 3-4 pumps, the Crosman pistol is also very silent.

Pumping the 1377C is very easy if you do not attempt to go for all the 10 pumps. Pumping will get progressively harder, but it is relatively effortless for the 4 pumps I go with now. The last couple of pumps in a 10 pump set are getting very hard; also, the pistol will make more noise at these settings.

The pistol has a safety bolt behind the trigger, which can be pushed on the left side to engage and on the right side to disengage.

After pumping the gun, you need to expose the breech and cock the trigger by pulling the bolt action back. Note that the bolt can slide back forward after this operation, if you tilt the gun, so you will want to keep it back while you load the pellet. Loading a pellet is a bit finicky - the problem is that the breech has a small step, so you cannot simply drop the pellet on it, you need to lift its tip a bit, so it gets into the barrel. Some pellets are easier to load than others. Once the pellet is properly seated, you can push the bolt and lock it. You should do this with little force, to make sure that you do not bend the pellet, if it is improperly seated. Once this is done, the gun is ready to shoot - aim, push the safety bolt out of the way, and then just pull the trigger.

Package and Build

Given its low cost, the American Classic comes with no case - just a plastic packaging that needs to be cut to remove the gun and manual out of it. I do not understand why they had to roll the manual in this package - I had to roll it the opposite way, in an attempt to straighten it out. Anyway, the only things you will need out of the packaging are the pistol and its manual.

The 1377C is made of metal and plastic. The frame of the pistol is metal, but the grips and the handle of the pump are plastic, as well as the receiver portion and the front sight. The rear sight is made of metal and is held in place by a screw - reversing it offers the option of switching between straight iron sights and a peep sight. Of special note is the bolt, which is made of brass and looks and handles very nicely. I do not mind plastic, as long as it is used in the right places and Crosman uses it in the right places here - I do not see anything likely to break soon in this assembly.

I should mention here that soon after I acquired the 1377C, I also purchased the 1399 shoulder stock that can be used with it, as well as with other Crosman airguns that share the same grips. This shoulder stock is made entirely of plastic and can be installed easily, by unscrewing the original grips, sliding it over the grip frame, and screwing it using the original grip screws. I have no criticisms for the build of this shoulder stock - it works exactly as intended; I was initially worried about whether its length would be suitable for an adult, but it turned out to be just the right length.

Adjustable settings

The only setting that can be adjusted is the rear sight. The rear sight consists of a metallic piece that is held into place by a screw. By loosening the screw, the sight piece can be raised or lowered to adjust elevation and can also be tilted left or right to adjust windage. By removing the screw, turning the sight upside down, and reattaching it with the screw, we get to use the peep sight. All this seems rather hard to adjust precisely, but in practice, on my gun, I only had to adjust it a bit for windage and it worked great from the first adjustment.

I recommend trying the peep sight first - I just find it more enjoyable to use than the standard iron sights post system.

Performance

The American Classic really delivers in the accuracy department. Put simply, it is one of the most accurate guns I have. It shoots well in factory setup (after sighting in), and mounting the 1399 shoulder stock will boost accuracy further by improving how well you can hold steady this long pistol. You can get very tight groups reliably with the 1377C/1399 combo - better than with any CO2 gun that I own.

Pumping the Crosman 4 times for target shooting is easy and the pistol works silently at this power setting - the sound of the pellet hitting the target will eclipse the sound of the pistol itself - the long barrel is probably also helping here, as the air gets to expand before the pellet gets out.

The only place where I would like to see improvement is the trigger. The 1377C trigger has little travel, is rather hard, and breaks rather unexpectedly. It is not as bad as it sounds, but I wish this gun had adjustable trigger settings. Crosman may want to consider producing a slightly higher end version with such a feature.

Maintenance is rather simple - use Pellgunoil on the pump joints and on the piston head. Work the oil in by using the pump without actually pumping any air - just start closing it until you feel resistance, open it, and then repeat this a few times while the oil works its way around.

Conclusion

The 1377C fully deserves its nickname of "American Classic". It is a very nice, simple and effective design that provides great accuracy for a very reasonable price. With varying power from the multi pump mechanism, this gun is also very versatile. The only thing I would change about it is the trigger - I would really like a lighter trigger, or even better - an adjustable one. There are very few airguns that offer such accuracy within this price range, so this is an easy choice.